Cone crusher main frame guard plate material use and daily maintenance

September 11, 2024

The material of the main frame guard plate of the cone crusher is casting, and its purpose is guard plate. ‌

The main frame guard plate of the cone crusher is an important part of the cone crusher. It is made of casting. This material has good wear resistance and durability, and can adapt to the use requirements in harsh environments such as mines. The main purpose of the guard plate is to protect the main structure of the cone crusher and prevent external factors from damaging the machine. At the same time, it can also reduce the frequency of maintenance and repair to a certain extent and extend the service life of the machine. In addition, the design and installation of the guard plate should take into account its wear resistance, durability and compatibility with other parts of the machine to ensure efficient and stable operation of the machine.‌

‌Maintenance of the main frame guard plate of the cone crusher‌ mainly includes daily inspection, cleaning, lubrication, and necessary tightening and replacement work to ensure its normal operation and extend its service life.

‌Daily inspection‌: Regularly check the various components of the main frame guard plate, including motors, bearings, gears, cylinders, etc., to ensure their normal operation and no looseness. At the same time, check whether the belt of the crusher is worn, loose, etc., and adjust or replace it in time. Check whether the safety protection device of the crusher is intact, and repair or replace it in time.

‌Cleaning and dust removal‌: Clean and dust the equipment to keep it clean and tidy. Clean the dust and debris on the dustproof seal sleeve and sliding ring frequently to avoid friction between the dustproof seal and the mineral particles bonded to the sliding ring, which will increase the wear of the dustproof seal.

‌Lubrication and maintenance‌: Regularly check the lubrication of the bearings, replace the lubricating oil in time, and ensure that the bearings are fully lubricated. The amount of lubricating oil added should account for 50%-70% of the volume of the housing, and it needs to be replaced at least once every three months. Lubricate the top bearing and horizontal shaft regularly, pay attention to check the lubrication of each part frequently and pay attention to adjusting the protection of the oil pipe.

‌Tightening and replacement‌: Check fasteners regularly, such as cylinder body, liner, etc., and tighten or replace them in time if they are loose or worn. Check whether the connecting bolts of various parts of the crusher are loose, cracked, etc., and repair or replace them in time.

‌Special precautions‌: When the crushed material is wet or has a high water content, the fixing bolts of the dustproof sealing slip ring should be checked frequently to prevent it from falling off and causing dust and ore sand to enter the equipment body. Safety operating procedures should be followed during maintenance to prevent accidents.

Author:

Ms. Janice Liu

E-mail:

manage@bodamachinery.com

Phone/WhatsApp:

+86 18355529650