Crusher dynamic balance correction operation process

September 02, 2024

Dynamic balancing of a crusher is a process of balancing the rotating parts to reduce vibration and noise and improve the performance and life of the equipment. Here are the general steps for dynamic balancing of a crusher:

Inspection: First, conduct a comprehensive inspection of the rotating parts of the crusher, including the main shaft, rotor, flywheel, etc. Check for looseness, wear, deformation or other damage.

Accurate measurement: Use professional dynamic balancing test instruments to accurately measure the rotating parts of the crusher. This can include detecting the mass distribution and imbalance of the rotating parts.

Determine the correction position: Based on the measurement results, determine the imbalance position and weight distribution on the rotating parts. This will guide the specific operation of the correction.

Add balance: According to the correction position and weight requirements, add appropriate balance to compensate for the imbalance. The balance can be a small piece of metal or other material attached to the rotating part.

Balance correction: Attach or install the balance to the specified correction position to balance the rotating part. Depending on the needs, multiple iterations may be required until a satisfactory balance effect is achieved.

Retest: After the correction, measure the crusher again using the dynamic balancing test instrument to ensure that the balancing effect is as expected and meets the requirements.

Effect verification: After the balancing correction, test the vibration and noise levels of the crusher to ensure that they are within the acceptable range and verify the effect of the balancing correction.

It should be emphasized that the dynamic balancing correction of the crusher usually needs to be performed by experienced professional technicians or balancing experts to ensure the accuracy and effect of the correction. For specific models and brands of crushers, the correction guidelines and recommendations provided by the manufacturer should be followed.

Author:

Ms. Janice Liu

E-mail:

manage@bodamachinery.com

Phone/WhatsApp:

+86 18355529650