Installation technical measures for crusher

The installation technical measures of the crusher mainly include the following aspects: ‌

Preparation work before installation: ‌

Check whether the various parts of the crusher are intact, and adjust the bolts and scales of each machine. ‌
Ensure that the installation environment and conditions meet the requirements, especially the grounding strength must meet the requirements of the factory. ‌
Ensure that the positioning of each shaft component is accurate and meets the conditions for the normal operation of the crusher. ‌
Ensure that the load of the crusher is within the set range to ensure safe operation and reduce mechanical failures. ‌
Ensure the horizontality and verticality of the crusher, the bolts must be firmly fixed, and professionals are used to install it. ‌
Installation technical measures: ‌

Lay impact-resistant rubber, plastic and other linings on the installation foundation to reduce machine noise and surface scratches. ‌
Install the main parts according to the drawing position, check whether the bolts are loose and tighten them in time. ‌
After completing the installation, check the reducer, bearing temperature, and whether the speed controller of the motor is adjusted to meet the requirements. ‌
Perform reliability test on the crusher. ‌
Environmental layout and infrastructure: ‌
The site selection should be based on production needs, such as the quarry should be close to the raw material supply site. ‌
Use prestressed concrete components as the foundation to meet the load-bearing and stability requirements. ‌
The drainage system should be set at a low place to prevent the machine from being damaged by moisture. ‌
Equipment installation sequence: ‌
Install the transmission device, base, frame, motor, conveyor, etc. in sequence. ‌
Use expansion bolts for fastening to ensure stability. ‌
Apply wear-resistant coating on the wear-resistant inner lining plate, set dynamic and static blade lining plates to enhance crushing strength and prevent wear. ‌
Electrical connection and protection: ‌
The ground wire should be connected first, and then connected to other parts, using standard wires. ‌
Set up a circuit protection switch to prevent overvoltage or short circuit from damaging the circuit hardware. ‌
Through the above measures, the safe and stable operation of the crusher can be ensured, production efficiency can be improved and service life can be extended